Ao Smith Water Heater Pilot Light Won't Light - agents

It looks atrocious and it should be shined up!

Smith water heater won't stay on.

I have a 2 years old a o smith gnr 50 200 water heater.

I don't have any difficulty getting the pilot light lit as some other users have indicated.

Turned the control knob to pilot and pressed.

Ao smith water gas water heater:

After my vacation, the pilot light went out.

The igniter is working as we see the initial spark but then it dies down when we click the.

There used to be a problem with it where the pilot wouldn't stay lit for more than 15 minutes after i would light it and turn the heater on.

Let an ao smith rep repair it.

There is residual gas inside the unit.

Hello, i have an ao smith gcv 40 water heater.

I have an ao smith water heater and the pilot suddenly won't stay lit.

It's the piece of metal coming out of the white insulator.

You would only be charged labor.

I have an a. o. smith model gcv 50 100, 50 gallon natural gas water heater that will not stay lit and the pilot goes out.

I have replaced the thermocouple and cleaned the flame arrestor, but the.

With this in mind, here are the most common reasons that a pilot won't light or won't stay lit and what you can do about them.

There is no light on the water heater.

After peeking through the little window, i see the pilot is lighting, but once i remove my finger.

📸 Image Gallery

If you really want to keep the water heater going, consider replacing the.

I have taken very good care of them, i flush them once a year, change the anode rods as needed, keep them.

I timed it and there.

The status red light stopped blinking and the water heater quit heating water.

Pilot light is lit but burner does not light.

I can hold the button down for a.

I had a handyman come in and change the thermocouple on the water heater too, it still wont light.

But if that heater was kicking off from the thermal switch, that would need to be reset manually.

I tried lighting in following the directions on the water heater and it will not light.

So i attempted to light the pilot doing the following:

Nevermind that the click starter does not work, but to get around that, i manually lit the pilot, and everything was fine, but.